J Downs Plumbing LLC
Your Cart is Empty
There was an error with PayPalClick here to try again
Thank you for your business!You should be receiving an order confirmation from Paypal shortly.Exit Shopping Cart
|Posted on January 14, 2014 at 7:29 PM||comments (2)|
Flushing a water heater is a simple, but effective maintenance task that will extend the life of your Water Heater, and also increase it’s operating efficiency. As the years pass, Sediment gets trapped in your Water Heater, which over time can build up and eventually prevent the drain valve from working. Also, Iron, Magnesium and Calcium can build up on the bottom of the water heater, which will discolor, or rust your hot water taps.How to Flush Your Water Heater
1. Turn off the Power (if the tank is electric), or set the Gas to the lowest setting, or Pilot if you have a Gas Water Heater.
2. Turn of the Cold Water Supply to the heater, which is usually at the top of the Water Heater.
3. Attach your garden hose to the drain valve at the bottom of the Water Heater.
4. Open the Hot Water Faucets in the house, to let the tank drain quicker.
5. Open the drain valve on the Water Heater and let it drain completely. This could take some time as the drain may be slowed by sediment. Also, be careful when opening the drain that you don’t use too much force, and break the valve.
6. After the Water Heater has completely drained, close the drain valve, and open the Cold Water Supply. Fill the Water Heater about half way, and then close the Cold Water Supply. Repeat Step 5 again. If the water coming out of the Drain Host is clear, you can stop. If not, repeat this step again.
7. Once the Water draining out of the Water Heater is clear, you can close the Drain Valve, and open the Cold Water Valve to let the Water Heater Fill up.
8. Open up all of the Hot Water Faucets in the house to let any air out of the system.
9. Turn the electric back on to the Water Heater, if it’s electric, or turn up the gas to the original position if you have a gas Water Heater.That’s it, you’re done! These simple steps have added years to your Water Heater and increased it’s efficiency. If any of these tips of steps are above your DIY comfort level, please call the professional plumbers at J. Downs Plumbing.